To Next Page

To Previous Page

4. Troubleshooting

Code 10040: “formatter - blue satellite thermal shutdown” (Error)

Situation Solution

The satellite is in shutdown

due to over temperature.

Check the dust ﬁlters, check the fan speeds in communicator. If the

problem persists, escalate the issue including a log package from the

system.

Code 10041: “formatter - blue satellite offset under voltage” (Error)

Situation Solution

The offset voltage on the

satellite is too low.

Restart the projector. If the problem persists, escalate the issue

including a log package from the system.

Code 10042: “formatter - blue satellite reset under voltage” (Error)

Situation Solution

The reset voltage on the

satellite is too low.

Restart the projector. If the problem persists, escalate the issue

including a log package from the system.

Code 10043: “formatter - blue satellite bias under voltage” (Error)

Situation Solution

The bias voltage on the

satellite is too low.

Restart the projector. If the problem persists, escalate the issue

including a log package from the system.

Code 10044: “formatter - blue satellite conﬁguration error” (Error)

Situation Solution

There was an error while

conﬁguring the satellite.

Restart the projector. If the problem persists, escalate the issue

including a log package from the system.

Code 10045: “formatter - blue satellite sri link error” (Error)

Situation Solution

There is a communication

error between ICMP and the

satellite.

Restart the projector. If the problem persists, escalate the issue

including a log package from the system.

Code 10046: “formatter - blue satellite in reset” (Error)

Situation Solution

The satellite is in the reset

state.

Restart the projector. If the problem persists, escalate the is

sue

including a log package from the system.

Code 10050: “gip - no SMS.be communication” (Error)

Situation Solution

The GIP module has failed

to connect with the SMS.be

module.

Restart the projector. If the problem persists, escalate the issue

including a log package from the system.

Code 10051: “gip - write to SMS.be failed” ( Error)

Situation Solution

The GIP module could not

send a command to the

SMS.be module.

Retry the action. Restart the projector. If the problem persists, escalate

the issue including a log package from the system.

R5906594 ICMP 09/11/2016 21

Brand	Barco
Model	ICMP
Category	Server
Language	English

Barco ICMP User Manual

Table of Contents

Other manuals for Barco ICMP

Questions and Answers:

Barco ICMP Specifications