1. Preliminary Remarks
1.2.6 Unpacking of devices
Note advices on the packaging for unpacking!
1.2.7 Modification of devices
Mechanical or electrical modifications others than described in this manual must not be made to the devices.
Barco is not liable for damages resulting from modified devices.
Only authorized personnel should carry out
other maintenance work not explicitly
mentioned in this user's manual!
Never open the case of the display without
first disconnecting the device from the AC
inlet. Measurements and tests with an
opened device may be carried out only in
the factory or by specially trained person-
nel, due to the dangers of electrical shock.
Seul le personnel autorisé devrait effectuer
d'autres travaux d'entretien qui ne sont
pas explicitement mentionnées dans le
manuel de l'utilisateur!
Ne jamais ouvrir le boîtier de l'écran sans
avoir d'abord débrancher l'appareil de la
prise secteur. Mesures et essais avec un
dispositif ouvert peuvent être effectués
que dans l'usine ou par un personnel
spécialement formé, en raison des dangers
de décharge électrique.
1.2.8 Cleaning
• Disconnect the device from the AC inlet.
• Spray water onto a soft cloth 2 to 4 times, and use it to clean the front frame.
Scrub gently to prevent scratching.
Wipe in one direction only! Too much moisture may cause staining.
• Do not use benzene, paint thinner or alcohol!
1.2.9 Moving the product
• Make sure to switch off the product.
• Make sure to unplug all cables from the product.
• 2 people carry each edge. Screen showing upwards.
1.2.10 Disposal or handing over to a new owner
• It is recommended to initialize the unit by resetting it to factory's default.
• Do not mix with other general waste.
• Do not dispose the LCD display in waste treated by a waste treatment center.
Barco - LCD 5521 V4 - R591734 - Installation manual - Revision 00 - March-2017
__________________________________________________________________________
17
To Next Page
Loading...
Need help?
General