5. Advanced operation
5.4 Key indicato r lights
About the key indicator lights
By default, after lighting up, the key indicator lights will dim again if no further actions are taken within the
following 5 seconds. However, this behavior can be changed so that the key indicator lights are always
on or always off.
To configure the key indicator lights
1. Bring up the OSD main menu.
2. Navigate to the Configura tion > User Interface > Indicator Lights menu.
3. Enter the Keys submenu.
4. Select Automatic/Always On/Always Off as desired and confirm.
5.5 Power lock function
About the power lock function
By enabling the power lock function, the NIO 3MP LED Display is forced to remain switched on. This
means that it can’t be switched to stand-by mode until the power lock function
is disabled again.
To enable/disable the power lock function:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > User Interface > Controls menu.
3. Enter the Power Lock submenu.
4. Select Enabled/Disabled as desired and confirm.
5.6 Ethernet ove r USB
About Eth. over USB
By default, the Ethernet over USB will be disabled. This does not disable the USB hub and still allows
to make use of the display’s USB downstream connectors and any external devices connected to it (key-
board,mouse,...).
Please note that a connection from a PC USB downstream connect
or to the display’s USB upstream
connector is required to be able to use this functionality.
By enabling the Ethernet over USB, you allow the internal NIO 3MP LED Display processor to communi-
cate directly over USB with the connected PC.
Enabling the USB endpoint is only recommended when you are using a non-Barco dis-
play controller. If y ou are using a Barco display controller, this communic ation will au-
tomatically be done ov er the connected video cable(s).
To enable/disable the eth. over USB:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Connectivity menu.
3. Enter the Eth. over USB submenu.
4. Select Enabled/Disabled as desired and confirm.
20
K5902067 NIO 3MP LED DISPLAY 10/04/2013
To Next Page
Loading...
Need help?
General
