Installing your Barco display controller
28 Nio display systems
7. Align the display controller(s) for your BARCO NIO Display System
with the slot(s) and press it(them) in firmly until the card(s)
is(are) fully seated.
8. Note: This step applies only to the MXRT 5100 and MXRT 7100.
Connect the power cable to the 6-pin power connection on the
graphics card. Make sure the cables are not interfering with
anything inside the computer (for example, a cooling fan).
Figure 6: Power connection for the MXRT 5100 and 7100 controllers
9. Screw in or fasten the display controller securely. Replace and
secure the computer cover.
10. Connect your Nio displays to the display controller(s) for your
B
ARCO NIO Display System using the cables supplied. Make sure all
cables are securely connected before turning on your system.
Figures 7 and 8 show the types of connections are available:
6-pin graphics controller
power cable
To Next Page
Loading...
