Installing your Barco display controller
30 Nio display systems
12. Turn on the display(s) and then your computer.
Turning on your system
If you have properly installed your graphics card, the Windows
start-up messages will appear once the boot procedure is finished.
13. Install the drivers, QAWeb software and documentation for your
B
ARCO NIODisplay System by following the instructions in the
section “Installing drivers and software” on page 46 of this
manual.
WARNING - Turn on your display(s) before you turn on
your computer. Failure to do so could damage your dis-
play(s).
Your Barco display(s) will be running in a basic video
mode at a default refresh rate. Higher resolutions and
refresh rates, such as 1536x2048@60Hz, are not avail-
able at this stage of the installation. Once you have
installed the B
ARCO NIODisplay System drivers and soft-
ware, the Barco monitor Plug and Play software should
automatically set the resolution for the displays of your
Nio display.
To Next Page
Loading...
