Installing drivers and software
Nio display systems 49
its compatibility with Windows XP message. If it does click Yes or
Continue to complete the driver and software installation.
Automated display configuration
Once the drivers, software and documentation have been installed and
your system has been rebooted, the Barco Monitor Plug and Play
Software should automatically detect your Barco displays and attach
them to the desktop with the correct resolution. If the Barco Monitor
Plug and Play Software fails to detect your Barco displays or fails to
attach them to the desktop correctly please refer to the section, Setting
the resolution of your Nio display on page 64 in the Troubleshooting
section of this manual.
Reinstalling drivers
You can install new drivers or reinstall existing drivers at any time by
using the Barco Set-up wizard on your B
ARCO NIODisplay System
Installation CD-ROM, see Installing the B
ARCO MXRT drivers and
software on page 46 of this manual.
Uninstalling the drivers and software
To uninstall the Barco drivers, software or documentation for your Nio
display Systems, please use the Windows Add/Remove Programs utility.
This can be found in the Windows Control Panel.
Note: When uninstalling the Barco MXRT drivers, the devices
must be uninstalled in pairs. When the dialog box shown in
figure 23 appears select all of the devices listed.
To Next Page
Loading...
