R5911443 /03 UDM92
Definition of angle and linearity (length) in the bow warp procedure
Image 8–36
Symmetric bow correction
1. In the main menu, select Installation → Warp → Bow.
Image 8–37 Warp menu, Bow
The bow menu is displayed.
2. To enable bow correction, make sure the Bow slider is enabled (visible by the blue highlight).
3. To perform a symmetric adjustment , make sure the Symmetric slider is set to On (visible by the blue
highlight).
Image 8–38 Both the Bow and Symmetric sliders are set to on
4. Use the arrow keys to select the helping lines that represent the picture and confirm.
The helping lines that represent the projected picture are now colored blue, while the others are colored
white.
GUI – Installation
To Next Page
Loading...
