Bartec Pro Series User Manual

Bartec USA TPMS PRO Series User Guide Rev5.1 Table of Contents
Page 13
1.9.3 SD Card Method
NOTE:
In order to receive updates by SD card, you must request to be part of the
SD card program.
Open the rubber boot on the top of the tool. Remove the old SD card by
pushing down to release it, then removing it from the SC card slot. Keep
the old SD card separate from the new one.
Insert the new SD card in the slot and push down until it clicks to lock in
place. Power your PRO Series tool on, and from the Home menu, select:
300PRO: My Tool > Enter Update Mode
400PRO: My Tool > Software Updates > Enter Update Mode
The tool will display “Insert USB Lead to Transfer Update Files”.
The tool will now load the update file to its operating system. Once the update is completed,
the tool will shut itself off.

Bartec Pro Series Specifications

General

Brand	Bartec
Model	Pro Series
Category	Diagnostic Equipment
Language	English