Bartec USA TPMS PRO Series User Guide Rev5.1 Table of Contents
Page 35
7.4 Passive Key (400PRO Only)
Passive Key or Push Button Start vehicles generally send out a LF signal to activate the key fob. Bartec has incorporated the
ability to detect those LF signals, and display that information on the screen of your tool.
This feature is a basic pass/fail test, and
assists the technician in determining if
there is a problem with the transmission
from the key fob or vehicle. Results may
vary depending on the MMY you are
testing.
After selecting the Passive Key feature,
hold the tool against the keyless entry pad
on the vehicle door, or touch the key fob
to the top of the tool and press any button
on the fob. The tool will display any signals
received.
7.5 Unlock REDI 7002A
If a REDI 7002A sensor has already been programmed and needs to be fitted to a different vehicle, it must first be “unlocked”.
Use this feature and follow the on-tool prompts to unlock the sensor.
8.0 My Tool
The My Tool menu allows the user to configure and manage their PRO Series TPMS tool.
Review this section to optimize the tool for your personal use.