B.link
Manual
26 / 32 v.1.1 © 2014 basalte
After defining all B.link Flex modules, add the controlled devices by using the Add Device button
or by drag-and-drop the codeset (right side) to the corresponding output. For each device, define
the Name, associated B.link Flex module Port
Define a logic name for the connected device, select the B.link Flex module where the device is
connected to and select the codeset applicable for this device. If you select an infrared output
module you also have to define to which port the infrared emitter of the device is connected (either
port 1, 2 or 3).
To Next Page
Loading...