Image Acquisition Control
Basler scout 107
Camera.AcquisitionFrameRateEnable.SetValue( true );
Camera.AcquisitionFrameRateAbs.SetValue( 60.0 );
// Start frame capture
Camera.AcquisitionStart.Execute( );
For detailed information about using the pylon API, refer to the Basler pylon Programmer’s Guide
and API Reference.
You can also use the Basler pylon Viewer application to easily set the parameters.
For detailed information about using the pylon API, refer to the Basler pylon Programmer’s Guide
and API Reference.
You can also use the Basler pylon Viewer application to easily set the parameters.
For more information about the pylon Viewer, see Section 3.1 on page 43.
7.6.2 Using a Software Acquisition Start Trigger
(Legacy Mode)
7.6.2.1 Introduction
If the Trigger Mode parameter for the acquisition start trigger is set to on and the Trigger Source
parameter is set to software, you must apply a software acquisition start trigger signal to the camera
to begin each frame acquisition. Assuming that the camera is in a "waiting for acquisition start
trigger" acquisition status, frame exposure will start when the software acquisition start trigger signal
is received by the camera. Figure 44 illustrates frame acquisition with a software acquisition start
trigger signal.
When the camera receives a software trigger signal and begins exposure, it will exit the "waiting for
acquisition start trigger" acquisition status because at that point, it cannot react to a new acquisition
start trigger signal. As soon as the camera is capable of reacting to a new acquisition start trigger
signal, it will automatically return to the "waiting for acquisition start trigger" acquisition status.
When you are using a software trigger signal to start each frame acquisition, the camera’s Exposure
Mode parameter must be set to timed. The exposure time for each acquired frame will be
determined by the camera’s exposure time parameters.
To Next Page
Loading...
