Why is my Basler Security Camera blinking red?
The continuous red blinking on your Basler Security Camera indicates that an overtemperature or overvoltage condition has been detected. The blinking should stop once the temperature or voltage returns to normal. You can reset the camera or power it off and then back on to resolve this.
How to fix Basler L304kc Security Camera when the LED is not lit?
If the LED on your Basler Security Camera is not lit, it indicates that the camera is not receiving power or the voltage is less than 10.8 Volts. Check the power connection and voltage supply.
What to do if the Basler Security Camera power source is not OK?
If the power source for your Basler Security Camera is not working correctly, use a voltmeter to check it. The output must be 12 VDC ± 1.2 V. Also, ensure that the power source meets all the specifications.
What to do for overtemperature problem in Basler L304kc Security Camera?
If your Basler Security Camera is experiencing an overtemperature issue, switch off the input power and allow the camera to cool down. Before resuming use, ensure that you are meeting the operating temperature requirements.
How to resolve overvoltage problem in Basler L304kc?
If your Basler Security Camera has an overvoltage problem, immediately switch off the input power. Correct the power supply to meet the specified requirements, and then reapply power to the camera.
What does 5 slow orange blinks mean on a Basler L304kc?
A repeated pattern of 5 slow orange blinks on your Basler Security Camera indicates a parameter error. This means a parameter is set out of range or to an invalid value.
What does 3 slow orange blinks mean on a Basler Security Camera?
A repeated pattern of 3 slow orange blinks on your Basler Security Camera indicates that the last shading table generation process failed. The blinking will stop when you successfully complete a generation process or you reset the camera.
What does 2 slow orange blinks mean on a Basler L304kc?
A repeated pattern of 2 slow orange blinks on your Basler Security Camera indicates one of the following errors: the maximum allowed line rate has been exceeded, or ExSync has not changed state for 5 seconds or longer. Check the cable and the ExSync generating device.
What does 6 slow orange blinks mean on a Basler Security Camera?
A repeated pattern of 6 slow orange blinks on your Basler Security Camera indicates that an erroneous parameter set has been loaded. To fix this, load another parameter set.
General| Sensor Type | CMOS |
|---|---|
| Lens Mount | C-mount |
| Connectivity | GigE |
| Shutter Type | Global shutter |
| Field of View | Depends on lens |
To Next Page
