Configuring the Camera
4-8 BASLER L304kc
Draft
Microcontroller Firmware Version Inquiry
FPGA Firmware Version Inquiry
FPGA Configuration Version Inquiry
Register Base Address: 0x0700
Field Name: Register Status Offset: 0x0000 Size: 1 Byte Type: Read only
Description: The integer value in this field indicates the status of this inquiry register:
0x00 = The register is not available
0x01 = The register is available.
Field Name: Microcontroller Firmware Version Offset: 0x0001 Size: 3 Bytes Type: Read only
Description: The value in this field indicates the camera’s microcontroller firmware version information.
The bytes in the field are interpreted as follows:
Byte 1 = Low byte of the firmware version (BCD coded)
Byte 2 = High byte of the firmware version (BCD coded)
Byte 3 = Register layout ID (BCD coded)
Register Base Address: 0x0800
Field Name: Register Status Offset: 0x0000 Size: 1 Byte Type: Read only
Description: The integer value in this field indicates the status of this inquiry register:
0x00 = The register is not available
0x01 = The register is available.
Field Name: FPGA Firmware Version Offset: 0x0001 Size: 3 Bytes Type: Read only
Description: The value in this field indicates the camera’s FPGA (field programmable gate array) firm-
ware version information. The bytes in the field are interpreted as follows:
Byte 1 = Low byte of the firmware version (BCD coded)
Byte 2 = High byte of the firmware version (BCD coded)
Byte 3 = Register layout ID (BCD coded)
Register Base Address: 0x0910
Field Name: Register Status Offset: 0x0000 Size: 1 Byte Type: Read only
Description: The integer value in this field indicates the status of this inquiry register:
0x00 = The register is not available
0x01 = The register is available.
Field Name: FPGA Firmware Version Offset: 0x0001 Size: 3 Bytes Type: Read only
Description: The value in this field indicates the camera’s FPGA (field programmable gate array) con-
figuration version information. The bytes in the field are interpreted as follows:
Byte 1 = Low byte of the configuration version (BCD coded)
Byte 2 = High byte of the configuration version (BCD coded)
Byte 3 = Register layout ID (BCD coded)
To Next Page
Loading...
