Operation and Features
3-40 BASLER L304kc
Draft
3.9 Mirror Image
L304kc cameras are equipped with a mirror image feature. When the mirror image feature is
enabled, the pixel values for each line will switch end-for-end about the line’s center point. In other
words, the value for pixel 1 will be swapped with the value for pixel 4080, the value for pixel 2 will
be swapped with the value for pixel 4079, the value for pixel the 3 will be swapped with the value
for pixel 4078, and so on.
3.9.1 Enabling Mirror Image
You can enable and set the mirror image feature with the Camera Configuration Tool Plus (CCT+)
or by using binary write commands from within your own application to set the camera’s control
and status registers (CSRs).
With the CCT+
With the CCT+ (see Section 4.1), you use the Mirror Mode parameter in the Output parameters
group to enable mirror imaging.
By Setting CSRs
You enable mirror imaging by writing a value to the Mode field of the Mirror Image Mode CSR (see
page 4-31).
See Section 4.2.2 for an explanation of CSRs and Section 4.3.1 for an explanation of using read/
write commands.
To Next Page
Loading...
Need help?
General
