Physical Interface
Basler scout 49
5 Physical Interface
This chapter provides detailed information, such as pinouts and voltage requirements, for the
physical interface on the camera. This information will be especially useful during your initial
design-in process.
5.1 General Description of the
Connections
The camera is interfaced to external circuity via connectors located on the back of the housing:
an IEEE 1394b socket used to provide power and a bus connection to the camera.
a 12-pin receptacle used to provide access to the camera’s I/O ports.
There is also an LED indicator on the back.
The drawing below shows the location of the two connectors and the LED.
Fig. 32: Camera Connectors and LED
To Next Page
Loading...
