Bauer Mini Verticus - Electrical Panel Components; PLC System Components

MNL-126509
April 4, 2013 Page 67
4.3.2 Cartridge Replacement
To change the purification cartridge, proceed as follows. (See Figure 4-11)
1. Disconnect the power and shut off the inlet supply line, if applicable.
2. Depressurize the system by means of the bleed valve.
3. Unscrew the chamber head using the special wrench supplied.
Figure 4-9 Oil and Water Separator Figure 4-10 Sintered Metal Filter Assembly
1. Filter Head
2. Sintered Metal Filter
3. Center Screw
4. O -rings
Figure 4-11 Cartridge Replacement
1
2
3
4
Pull
Up