4.6.5. Flash Signal �� 25

4.6.6. Frame Counter �� 25

4.7. User Sets �� 26

4.8. Factory Settings �� 26

4.9. Timestamp �� 26

5. InterfaceFunctionalities ........................................................................................ 27

5.1. Device Information �� 27

5.2. Packet Size and Maximum Transmission Unit (MTU) �� 27

5.3. Inter Packet Gap �� 27

5.3.1. Example 1: Multi Camera Operation – Minimal IPG �� 28

5.3.2. Example 2: Multi Camera Operation – Optimal IPG �� 28

5.4. IP Conguration �� 29

5.4.1. Persistent IP �� 29

5.4.2. DHCP (Dynamic Host Conguration Protocol) �� 29

5�4�3� LLA �� 30

5.4.4. Force IP �� 30

5.5. Packet Resend �� 31

5.5.1. Normal Case�� 31

5.5.2. Fault 1: Lost Packet within Data Stream �� 31

5.5.3. Fault 2: Lost Packet at the End of the Data Stream �� 31

5.5.4. Termination Conditions �� 32

5.6. Message Channel �� 33

5.6.1. Event Generation �� 33

5.7. Action Command / Trigger over Ethernet �� 34

5.7.1. Example: Triggering Multiple Cameras �� 34

6. Start-Stop-Behaviour ............................................................................................. 35

6.1. Start / Stop Acquisition (Camera) �� 35

6.2. Start / Stop Interface �� 35

6.3. Pause / Resume Interface �� 35

6.4. Acquisition Modes �� 35

6.4.1. Free Running �� 35

6.4.2. Trigger �� 35

7. NotesandInstructions .......................................................................................... 36

7.1. Warranty Notes �� 36

7.2. Lens Mounting �� 36

8. Conformity .............................................................................................................. 37

8.1. CE �� 37

8.2. FCC – Class B Device �� 37

Index .............................................................................................................................. 38

Baumer EXG03 User Manual

Questions and Answers: