WARNING!
Danger due to use other than intended!
Any use of the device different from and/o
r exceeding beyond the scope of the intend-
ed use can lead to dangerous situations.
Therefore:
m Only use the device as intended.
m Follow all specifications of this
Operation Manual.
m Ensure that exclusively qualified per
sonnel work on or with this device.
m Take care in project planning to see that the device i
s always used within its spec-
ifications.
m The device and/or mounting rail is mounted on a w
all which is sufficiently sturdy.
m Ensure that the power supply meets the
required specifications.
m Only operate the device if it is in technically faultless condition.
m Only use the device in combination with co
mponents approved by Baumüller Nürn-
berg GmbH.
Safety
Operation Manual Safety I/O Terminals SI4000 / SO4000
Document no.: 5.08009.05
17
of 82
3
3.4 Operator responsibility
The device is implemented in an industrial zone. The operator of the device is thus sub-
ject to the legal work safety obligations
.
In addition to the work safety in
structions in this Operation Manual, the safety, accident
prevention and environmental protection regulations applicable to the area of application
of this device must also be complied with. In doing so, the following applies in particular:
m The operator must inform himself of the applicab
le work safety regulations and addi-
tionally ascertain hazards arise through the special w
ork conditions at the place of use
of the device in a risk assessment. The operator must implement this in the form of op-
eration instructions for the operation of the device.
m This Operation Manual must be kept in the
immediate vicinity of the device and be ac-
cessible to persons working on and with the device at all times.
m The statements of the Operation Manual are to b
e followed completely and absolutely!
m The device may only be operated in technically fau
ltless condition and must be safe for
operation.
3.5 Protective equipment
Protection category
SI4000 IP 20
SO4000 IP 20
All SI4000 and SO4000 devices with the couple stations (b maXX safe PLC or bus cou-
pler) must be built into a suitable electrical cabinet in order to comply with the protective
catego
ries (IP54) required in EN 60529.
To Next Page
Loading...