Storage conditions
Operation Manual Safety I/O Terminals SI4000 / SO4000
Document no.: 5.08009.05 Baumüller Nürnberg GmbH
62
of 82
9.5
Figure 16:
1 Carefully pull the orange-colored lug approximately 1 cm out of the disassembled ter-
minal, until it protrudes loosely. The lock with the
mounting rail is now released for this
terminal, and the terminal can be pulled from the mounting rail without excessive force.
2 Gra
sp the released terminal with thumb and index finger simultaneous at the upper and
lower grooved housing surfaces and pull the terminal away from the mounting rail.
9.5 Storage conditions
Store the terminals in suitable packaging according to the storage conditions in
ZAp
pendix D - Technical Data– from page 71 onward.
9.6 Recommissioning
If you want to recommission the terminals, observe the information in "Storage Condi-
tions" in ZAp
pendix D - Technical Data– from page 71 onward.
Then, carry out ZAss
embly and Installation– from page 35 onward again.
9.7 Disposal
In order to dispose of the device, it must be removed and fully dismantled.
m Housing components (polycarbonate,
polyamide (PA6.6)) are suitable for plastic re-
cycling.
m Metal parts can be sent for metal recycling.
m Electronic parts such as disk drives and cir
cuit boards must be disposed of in accor-
dance with national electronics scrap regulations.
To Next Page
Loading...