56
© Baxi Heating UK Ltd 2017
19.0 ‘Service Due’ Message
‘Service Due’ Message Resetting/De-activation/Activation
The message is NOT ACTIVATED as a factory setting
but can be activated at any time.
1. When activated the ‘Service Due’ message will be shown
on the boiler display after 11 months operation . (If the
installation has been subject to prolonged electrical isolation
or power cuts this period may be longer than 11 months)
2. Once the service has been completed satisfactorily the
‘Service Due’ message can be reset or de-activated.
To Reset
If the function requires resetting proceed as follows:-
4. Press & for 6 seconds. Using scroll
through until
‘22’ is displayed. Press .
5. Press to scroll to
‘15’. Confirm with then
press to return the display to normal.
To De-activate
When the function is no longer required proceed as follows:-
6. Press & for 6 seconds. Using scroll
through until
‘22’ is displayed. Press .
7. Press until
‘22’ is displayed again. Press .
Using scroll through to
‘50’. Press .
8. Press until
‘25’ is displayed. Confirm with
then press to return the display to normal.
To Activate
If the function requires activating proceed as follows:-
9. Press & for 6 seconds. Using scroll
through until
‘22’ is displayed. Press .
10. Press until
‘22’ is displayed again. Press .
Using scroll through to
‘50’. Press .
11. Press until
‘11’ is displayed. Confirm with
then press to return the display to normal.
To Next Page
Loading...
Need help?
General
