Setting Up the Touchscreen and Cables
SETTING UP THE PREPSTATION CART
M00205 v1.1 Page 5
7. Draw the cable guide through
the tower until the cords are
amply threaded through the
opening.
Tip! It is better to have too
much available cord than too
little.
8. Tilt the touch-screen up.
Connect the power cord or USB
cable (depending on model) to
the monitor. Make sure the
cord hangs loosely.
Tip! Push any excess cable in
the hole on the upright, but
not so much that the cords are
pulled tight when the monitor
is tilted up. The cables should
be slack, but not messy.
CAUTION!
Taut cables can snap
when the touchscreen
is raised.
To Next Page
Loading...
Need help?
General
