If you fail to enter the Subnet Mask in
dotted decimal form, the DS73TP responds
again:
Enter Subnet Mask in dotted decimal form:
The DS73TP responds indefinitely with the
same request until the Subnet Mask is
entered in the correct form.
Gateway The Gateway is the address of a router for
connection to their networks. The Gateway
address consists of four bytes, each byte
ranging from 0 to 255. If your network
uses gateways, this parameter must be
programmed before the DS73TP can
access a network.
From the configuration menu, select #4,
“Gateway,” followed by <cr>. The DS73TP
responds:
Enter Gateway address in dotted decimal form:
Enter the Gateway address (Example:
200.4.5.50), followed by <cr>. The
DS73TP resumes the configuration menu.
Default Gateway address is 0.0.0.0.
If you fail to enter the Gateway address in
dotted decimal form, the DS73TP responds
again:
Enter Gateway address in dotted decimal form:
The DS73TP responds indefinitely with the
same request until the Gateway address is
entered in the correct form.
To Next Page
Loading...