BCM RX45Q - System Panel Connector (F

To Next Page

To Previous Page

RX45Q User’s Manual

1.1.26 System Panel Connector (F_PANEL1)

This connector supports several chassis-mounted functions.

 System Power LED (2-pin PWRLED)

This 2-pin connector is for the system power LED. Connect the chassis power LED cable to this

connector. The system power LED lights up when you turn on the system power, and blinks when the

system is in sleep mode.

 ATX Power Button/Soft-off Button (2-pin PWRSW)

This connector is for the system power button. Pressing the power button turns the system on or puts

the system in sleep or soft-off mode depending on the BIOS settings. Pressing the power switch for

more than four seconds while the system is ON turns the system OFF.

 Hard Disk Drive Activity LED (2-pin HDLED)

This 2-pin connector is for the SATA HDD Activity LED. Connect the SATA HDD Activity LED cable to

this connector. The SATA LED lights up or flashes when data is read from or written to the HDD.

 Reset Button (2-pin RESET)

This 2-pin connector is for the chassis-mounted reset button for system reboot without turning off the

system power.

BCM RX45Q - System Panel Connector (F_PANEL1)