VOIP Menu Cont’d
Security Menu
14
Features & Set-Up
Settings Menu
• Intercom - Camera (Disabled on G9W & G9W-S), Message - ON/OFF, Auto Answer - ON/OFF, Volume
• Network Settings
• DHCP: To automatcially assign an IP address, turn this ON, otherwise adjust the following settings:
• IP Address: Type an IP address to network your monitor to the system. Each IP must be unique.
(Example: 192.168.1.240)
• Mask: Default = 255.255.255.0 - usually, this does not need to be changed.
• Gateway: By denition, the default address of your router - must be the same on all monitors.
(Example: 192.168.1.1)
• DNS: If the indoor monitor is communicating to the internet, this must be set correctly.
(Typical default address would be 8.8.8.8 Google Public DNS)
• Password - Used for system settings (Default = 123456). Can be 1-16 digits.
• QR Code - Used with the IpCalls system application available for smartphones. System settings will be
syncrhonized automatcially, but only available for use on the local network.
Tap Security on the home screen to enter the
security menu.
ON/OFF - Tap to enter the security mode selection
menu. Tap “Out”, “Home”, or “Sleep” to activate the
alarm system. System sounds 2-beeps and icon
appears at the home screen when active.
• Press “OFF” when system is active to disarm.
(Default Pass = 1234).
Camera - Press camera to enter the IP camera menu.
• Tap to begin monitoring camera. Press to stop.
Select a specic camera using the or keys
• To setup camera access, log into the monitor webpage
via IP address in a web browser.
Use credentials: Username=user; Password=1234
To Next Page
Loading...
Need help?
General