Door Station Settings
NT-IP-A9K Set-Up
20
Features & Set-Up
Basic Operation
• When programmed as an “outdoor panel”, type at least 3 digits (oor + room) to
call a room.
(Example: 0312#)
• When programmed as a “wall station”, type the building no. + #, unit no. + #, +
Room no. + # (at least 7 digits).
• If room exists, monitor will dial and room monitor will ring. If device not found, a
failure tone and message will appear. If indoor monitor is busy, “Busy” will appear.
• During communication, “*” will end the call.
Unlocking the Door
• Press # then type the access password (Default = 0000). Press # to conrm. If
password is correct, door will unlock. If incorrect, an error will sound.
• To unlock via IC/ID card, swipe or place the fob on the card reader area of the
panel. If registered, the door will unlock.
NT-IP-DRG
NT-IP-A9K
NT-IP-DRS1
To Next Page
Loading...
Need help?
General