Becker AR 4201 - Inhibiting the Frequency Storage; Erase Stored Frequencies; Setting the “Channel Start” Scanning Range (Only Displayed, if SF8 Is Activated)

11 In hi bi ting the fre quen cy sto ra ge
a Call up functi on SF 11 using the MDE key. The fol lo wing
dis play ap pe ars.
Top line SF 11
Bot tom line OFF or On
b Se lect the re qui red functi on using the kHz switch and
sto re the se lec ti on by pres sing the STO key.
OFF = The sto ra ge of fre quen cies in the in di vi du al chan-
nels is not pos si ble. The VHF trans cei ver can only
work on the set fre quen cy.
On = Sto ra ge of fre quen cies in the in di vi du al chan nels
is pos si ble (stan dard set ting)
12 Era se sto red fre quen cies
a Call up functi on SF 12 using the MDE key. The fol lo wing
dis play ap pe ars.
Top line SF 12
Bot tom line CH chan nel num ber
b Se lect the chan nel to be era sed using the kHz (steps of
1) or MHz (steps of 10) switch. The sto red fre quen cy is
era sed by pres sing the STO key.
13 Set ting the “chan nel start” scan ning ran ge (only dis play ed, if
SF8 is ac ti vat ed).
a Call up functi on SF 13 using the MDE key. The fol lo wing
dis plays ap pe ar :
Top line SF 13
Bot tom line CS chan nel num ber
b Se lect the star ting chan nel, using the kHz (steps of 1) or
MHz (steps of 10) switch, at which the scan functi on is to
be gin. The star ting chan nel is sto red by pres sing the STO
key.
Note
When this functi on is set OFF, the ac ti ve and pre set fre -
quen cies which were set last re mains are avai la ble in
Mode 1
IN STAL LA TI ON AND OPE RA TI ON
AR 4201 - ( )
Page 3-15
23-10-01 De cem ber 15/98