Becker AR 4201 - Setting the Dynamic Mike Input Sensitivity; Entry of Password to Interlock the Equipment Configuration; Setting the Channel End Scanning Range (Only Displayed if SF8 Is Activated)

14 Set ting the “chan nel end” scan ning ran ge.(only dis play ed, if
SF8 is ac ti vat ed).
a Call up functi on SF 14 using the MDE key. The fol lo wing
dis plays ap pe ar :
Top line SF 14
Bot tom line CS chan nel num ber
b Using the kHz (steps of 1) or MHz (steps of 10) switch,
se lect the end chan nel at which the scan functi on is to
stop. Sto re the end chan nel by pres sing the STO key.
15 En try of pass word to in ter lock the equip ment con fi gu ra ti on.
a Call up the COdE functi on using the MDE key. The fol lo-
wing dis play ap pe ars.
Top line COdE 15
Bot tom line 0
b Set any 4-digit nu me ri cal code using the kHz (steps of 1)
or MHz (steps of 10) switch. Sto re the nu me ri cal code by
pres sing the STO key.
NOTE : As soon as a pass word is gi ven an 0 ap pe ars
in the bot tom line when the ser vi ce mode is
cal led up. The nu me ri cal code must then be
in put using the MHz or kHz switch. If the VHF
trans cei ver de tects a fal se nu me ri cal code, it
au to ma ti cal ly swit ches to the last mode.
If the pass word is to be era sed or chan ged,
this is done by cal ling up the ser vi ce mode
using the old pass word. The COdE functi on
is then cho sen and eit her an 0 is en te red
everyw he re or the chan ged nu me ri cal code
is en te red.
16 Set ting the dy na mic mike in put sen si ti vi ty
a Call up functi on SF 16 using the MDE key. The fol lo wing
dis plays ap pe ars :
Top line SF 16
Bot tom line 00 bis 63 Stan dard va lue 32
(LO sen si ti vi ty HI)
b The dy na mic mike in put sen si ti vi ty can be chan ged
up wards or down-wards using the kHz switch. The set
va lue is sto red by pres sing the STO key.
IN STAL LA TI ON AND OPE RA TI ON
AR 4201 - ( )
Page 3-16-
23-10-01 De cem ber 15/98