INTRODUCTION
1. General
The single block Mode S transponder BXP6401-X-(XX) is described in this manual
“Installation and Operation”.
2. Manufacturer
The Mode S transponder was developed and is manufactured by :
Becker Flugfunkwerk GmbH
Baden-Airpark B 108
77836 Rheinmünster / Germany
Telephone: +49 (0) 7229 / 305-0
Telefax: +49 (0) 7229 / 305-217
http://www.becker-avionics.de
e-mail: info@becker-avionics.de or support@becker-avionics.de
CERTIFIED QUALITY SYSTEM
The Becker quality management system is certified according to :
DIN EN ISO 9001:2008
and EN9100:2003/AS9100B Certificate Registration No. 12 210 20985 TMS
LICENSES AND APPROVALS
DE.21G.0075 Approval as manufacturer to EASA PART 21
DE.145.0166 Approval as maintenance organization to
EASA PART 145
3. Safety information
n
The installation of the Mode S transponder into an aircraft may be carried
out only by an authorized installation company. The country regulations
always have to be observed.
n
Do not connect the unit to AC sources.
n
Make sure that the unit is connected to a DC source £ 33 V DC.
n
If no load is connected to pin 6 of P9, the unit should be protected from the
aircraft power supply by a dedicated 3 A circuit breaker.
n
If an external load is connected to pin 6 of P9, the circuit breaker should
be a 5A type.
n
Do not connect the unit with reversed polarity to the DC source.
n
Do not switch on the unit before the aircraft engines are started. Switch off
the unit before the engines are shut down.
INTRO Page 1
34-50-08 September 2011
INSTALLATION AND OPERATION BXP6401-X-(XX)
To Next Page
Loading...