Becker Centronic SunWindControl SWC241 - General Information; General; Warranty Terms; Safety Guidelines

12
Assembly and Operating Instructions
General
Warranty
Safety tips
The SWC241 allows you to control one or several sun protection systems and to
set the threshold value for wind surveillance with the enclosed setting tool.
This device is excellent because it is so easy to operate.
Structural modications and incorrect installation which are not in accordance
with these and our other instructions can result in serious injuries, e.g. crushing
of limbs. Therefore, structural modications should only be carried out with our
prior approval and in accordance with our instructions, particularly the informa-
tion contained in these Assembly and Operating Instructions.
Any further processing of the products which does not comply with their intend-
ed use is not permitted.
The end product manufacturer and tter have to ensure that all the current stat-
utory, ofcial regulations and, in particular, EMC regulations are adhered to dur-
ing utilisation of our products, especially with regard to end product assembly,
installation and customer advice.
Danger
Please keep the instructions in a safe place!
• Use in dry rooms only.
• Use unmodied Becker original parts only.
• Keep persons away from the system guide track.
• Keep children away from controls.
• Please comply with national stipulations.
• Dispose of used batteries properly. Replace batteries by an identical
type (LR 03; AAA) only.
• If the system is controlled using one or several transmitters, the sys-
tem guide track must be visible during operation.
• Please refer to the specications given in the operating instructions
for the sun protection system