Becker Centronic SunWindControl SWC241 - Device Interface and Functions; Displays and Pushbuttons; Operational Functions

14
Assembly and Operating Instructions
Displays and pushbuttons
RETRACT button
STOP pushbutton
EXTEND button
Battery compartment
Setting aid
Wind threshold control switch
Programming pushbutton
Transmission control light
Functions
Transmission control light
A radio signal is indicated by the transmission control light being lit. If the battery
starts running out, the transmission control light ashes during transmission.
The transmitter power and/or radio range is reduced when the battery is run-
ning low. If the transmission control light is no longer lit when the pushbutton is
pressed, the batteries must be changed.
Group
Group control means controlling one or several receivers at the same time. The
programmed group is activated using a single command.