Becker PSF+ Series - Disposal; Maintenance; Technical Data Dia. 35

Readying the tubular drive for programming with the radio switch
Switch the radio switch to the inside position. If the radio switch is already in this posi-
tion, switch it to the outside and back to the inside position.
▻ The tubular drive is ready to programme for 3 minutes.
Now press the programming button of the new master transmitter for 10 seconds.
▻ The tubular drive makes a clicking sound to confirm.
► The new master transmitter is now programmed and the old master transmitter
overwritten.
Disposal
This product is made of various materials which must be disposed of properly. Find out about the applicable regulations on recyc-
ling or disposal for this product in your country.
The packaging material must be disposed of properly.
Maintenance
These drives are maintenance-free.
Technical data dia. 35
Type P5/20C
PSF
P5/30C
PSF
P9/16C
PSF
Rated torque [Nm] 5 5 9
Output speed [rpm] 20 30 16
Limit switch range 64revolutions
Supply voltage 230VAC / 50Hz
Connected load [W] 115 115 110
Rated current consumption [A] 0.47 0.47 0.47
Operating mode S24min
Degree of protection IP44
Min. tube inside diameter [mm] 37
Frequency 868.3MHz
Emission sound pressure level [dB(A)] ≤70
18