Parameterization and Commissioning
BC8050 und BC815036 Version: 3.0.0
4.5 RS232 interface
4.5.1 TwinCAT Configuration - RS232 Interface
TwinCAT 2.10 Build 1243 or higher is required for using the TC configuration.
Open the BC8150 template project.
Fig.33: Selection dialog "New from Template"
Select BC8150.
Fig.34: Selection of Bus Controller
Open the device (BC8150) and click on BC8150. On the right in the System Manager there are two tabs, i.e.
General and Communication Properties. Select Communication Properties. The following settings are
available. Watchdog setting - at 0 ms the watchdog is disabled, adjustable up to 64000 ms max. The baud
rate and parity are only valid if the address switch is set to 40-59. The input and output sizes are calculated
from the attached variables.
To Next Page
Loading...
