Decommissioning
84
─── Version: 1.0XPlanar
Disassembly may only be carried out by qualified and trained per-
sonnel.
Refer to chapter Documentation notes.
When disposing of electronic waste, make sure that you dispose of
it in accordance with the regulations applicable in your country.
Read and follow the instructions for proper disposal.
13.1
Disassembly
WARNING
Wear safety goggles and gloves
The movers can have strong magnetic attraction to each other or
other metallic objects. Splinters can form if magnets collide.
Failure to do so may result in serious injury to fingers and eyes.
Remove each mover individually from the box
If you take two movers out of the box and the distance between
the movers is too small, the movers can attract each other.
If the movers attract each other and collide, serious injuries to the
fingers from crushing and in the eyes from splinters can result.
Do not reach under the mover with your fingers
When carrying a mover or positioning it on the system, do not
reach under the mover with your fingers.
Failure to do so can result in severe crushing and injury to fin-
gers.
Do not remove components from the products
Only Beckhoff Automation GmbH & Co. KG is permitted to remove
components.
Contact Beckhoff Service if you have any questions.
Removing the XPlanar from the machine
• Remove cables and electrical connections
• Release the fastening screws of the modules
• Remove the modules from the machine one after the other
• Transport XPlanar components to the workplace or store them
To Next Page
Loading...
Need help?
General
