BEETEL 450TC3 - Specifications

6.5 Time .................................................................................................................................. 67
6.6 Log .................................................................................................................................... 68
6.7 Diagnostics ........................................................................................................................ 68
6.7.1 Ping ........................................................................................................................ 69
6.7.2 Tracert .................................................................................................................... 69
6.7.3 OAM loopback ....................................................................................................... 71
6.7.4 ADSL diagnostics ................................................................................................... 72
6.7.4 Diag-test ................................................................................................................. 74
1. Introduction
The 450TC3 ADSL2+ Wireless/Ethernet Router is a device with routing capability, wireless
access point, multiple ADSL lines transmission mode (ADSL2+, ADSL2, T1.413, G.Dmt and
G.lite) and provides 10/100Base-T Ethernet interface. The ADSL Router supports wireless
802.11n/b/g and the following security protocols: WEP, WPA, WPA2 and 802.1x. Through the
ADSL access, the router can provides user with access to Internet.
This user manual is mainly used to guide the user to install and configure the ADSL Router from
WEB UI.
1.1 Specifications
 Wireless AP, Router, 4 Port Switch and Firewall
 Support ITU-T G.992.1 (G.dmt), ANSI T1.413, G.992.2 (G.Lite), ADSL2 and ADSL2+
 Support 802.11n, compatible with 802.11b and 802.11g
 Up to 54 Mbps wireless operation rate
 64/128 bits WEP for security
 WPA and WPA2 support
 4 10/100MBase-T Ethernet interface (LAN)
 RFC-1483/2684 LLC/VC-Mux bridge/route mode
 RFC-1577 Classical IP over ATM
 RFC-2516 PPPoE
 RFC-2364 PPPoA
 ITU-T 1.610 F4/F5 OAM send and receive loop-back
 802.1d Spanning-Tree Protocol
 DHCP Client/Server/Relay
 NAT
 RIP v1/v2
 DNS Relay Agent