BEETEL 450TC3 - Port Mapping

enable or disable the CWMP
 URL
ACS URL.
 User Name
the username the device should use when connecting to the ACS
 Password
the password the device should use when connecting to the ACS
 Periodic Inform Enable
when this field is enabled, the device will send an Inform RPC to the ACS server at the
system startup, and will continue to send it periodically at an interval defined in “Periodic
Inform Interval” field; when this field is disabled, the device will only send Inform RPC to
the ACS server once at the system startup.
 Periodic Inform Interval
the interval to send Inform RPC
Connection Request parameters:
 User Name
username the remote ACS should use when connecting to the device
 Password
password the remote ACS should use when connecting to the device
 Path
the path of the device ConnectionRequestURL.
 Port
the port of the device ConnectionRequestURL.
5.3.5 Port mapping
The device provides multiple interface groups, up to five interface groups are supported including
one default group. Traffic coming from one interface of a group can only be flowed to the
interfaces in the same interface group. Thus, the device can isolate traffic from group to group for
soma application. By default, all the interfaces (LAN and WAN) belong to the default group, and
the other four groups are all empty. It is possible to assign any interface to any group but only one
group.
Go to Advanced->Port Mapping page, you can configure the mapping group.