2. Installation
2.1 Hardware installation
To install the device correctly, you should prepare as follows:
A RTL867x board
12V DC power
RJ-45 Ethernet cable
RJ-11 ADSL line
COM Port cable (Optional)
Then you can follow the procedures to setup the device:
1. Connect RJ-45 cable from your PC to RTL867x Ethernet Port
2. Connect RJ-11 line from RTL867x to DSLAM
3. Connect PC‟s COM port to RTL867x COM port if you have COM port cable. You can
monitor the status of system and input control command from PC‟s HyperTerminal.
4. Connect the 12V DC power
To Next Page
Loading...