(3) Wireless Access Control
Wireless access control function is used to allow or prohibit the client access to the wireless
network by MAC address.
Wireless Access Control Mode: it can be “disable”, “Allow Listed” or “Deny Listed”. If the
mode is “disable”, it means the wireless access control function is closed; if the mode is
“Allow Listed”, only the client on the list will be able to connect to you access point; if the
mode is “Deny Listed”, these wireless clients on the list will not be able to connect to you
access point.
MAC Address: the MAC address of the client you want to allow or prohibit
Current Access Control List: it show the MAC address table you configured, you can delete it
as you need.
(4) WDS
To Next Page
Loading...