To Next Page

To Previous Page

The system is organised in menus that allow you to access varied features of the system: turn

luminaires on and off, perform Functional and Autonomy Tests, review information on mal-

functions etc.

To understand how to navigate among screens using the keys, see section "Keyboard and

Display Functions".

Most operations available can be applied to the entire system or to parts of it, as shown in the

following table:

There are 3 menus: LUMINAIRES, MAINTENANCE AND STATUS.

LUMINAIRES MENU

Use this menu to adjust the brightness of the luminaires:

MAINTENANCE MENU

MANUAL TEST

Functional and Autonomy Tests check the emergency luminaires. A Functional Test consists in

turning on a luminaire for about 30 seconds during which time the luminaire tube and battery

efficiency is checked; an Autonomy Test consists in turning on a luminaire over a longer time

at the end of which the battery efficiency is checked.

Normally, Functional and Autonomy Tests are run automatically at regular intervals according

to the schedule set by the user (see Scheduling Functional and Autonomy Tests"), but it is also

possible to perform a Functional Test or an Autonomy Test directly from the keyboard: Manual

Test. Manual Tests stop at the end of the set time or by sending a stop test command.

For: go to (menu):

all luminaires in the system ALL

a single luminaire (e.g. luminaire LOGICA SA

code F01234)

SA/PS F01234

all luminaires in Group yy GROUP 03

go to (menu):

for a maximum brightness level ON (MAX)

to turn them off TO TURN THEM OFF

for an intermediate brightness level (e.g.

level 5)

DIMMER STEP 05

Beghelli LOGICA User Manual

Other manuals for Beghelli LOGICA