13
CONTROL UNIT MANAGEMENT
Date & Time Changes
To set the date and time on the Logica FM Control Unit,, see section "Date and Time Settings".
Printing
Note: Printing will be available if the Logica FM Control Unit is connected to a Logica DIN RS232
serial printer by Beghelli (code 3284).
The following data can be printed:
- Configuration: List of installed luminaires and their characteristics (model, even/odd-num-
bered, 1hr/3hrs autonomy etc.).
- Scheduling: Timetables for Functional and Autonomy Tests, time intervals for testing, stag-
gered testing on odd- and even-numbered luminaires.
- Errors: For each faulty luminaire, a warning is given that specifies the type of fault (e.g. 8W
neon tube error, battery charging error etc.).
- Reports: For this menu, you must enter a start date and an end date for the report. The prin-
tout will list significant actions that occurred over the set time frame involving the Logica Control
Units by Beghelli installed in the system. The printout will report the start time and the end
time of Functional or Autonomy Tests performed, be they manual or automatic tests, and a
list of faulty luminaires.
The following controls are available in the PRINT menu:
To: go to (menu):
print the Configuration CONFIGURATION
print the Scheduling SCHEDULING
print Errors ERRORS
print Reports REPORT
To Next Page
Loading...
Need help?
General