Behringer X32 - Sends on Fader

Sends on Fader
To use “Sends on Faders,” press the “Sends on Faders” button located near the middle of the console.
• You can now use “Sends On Faders” in one of two dierent ways.
1. Using 16 input faders:
• Select a buss on the output fader section on right and the input faders on the left will reect the mix being sent
to the selected bus.
2. Using 8 bus faders:
• Press the select button of an input channel on the input section on the left.
• Raise the bus fader on the right side of the console to send the channel to that bus.