Behringer X32 - Matrix Mixes

Matrix Mixes
• Matrix mixes can be fed from any mix bus as well as the MAIN LR and Center/Mono bus.
• To send to a Matrix, rst press the select button above the bus you want to send. Use the 4 rotary encoders in the
BUS SENDS section of the channel strip. Encoders 1-4 will send to Matrix 1-4. Press the 5-8 button to use the rst
two encoders to send to Matrix 5-6. If you press the “view” button, you will get a detailed view of the 6 Matrix
sends for the selected Bus.
• Access the Matrix mixes using layer 4 on the output faders. Select a Matrix mix in order to access its’ channel
strip, including dynamics with 6-band parametric EQ and x-over.
• For a stereo Matrix, select a Matrix and press the “view” button near the CONFIG/PREAMP section of the
channel strip. Press the rst encoder near the screen to link, forming a stereo pair. Note, stereo panning is
handled by even BUS SEND encoders as described on the “Using Buses” page in this guide.