PC / Mac Control Conguration
1. Download the latest version of Xcontrol from www.behringer.com/x32.
2. Connect the X32 “Ethernet” jack to a wireless router (for wireless use), or directly to your computer’s Ethernet port.
3. Open your computer’s Network Settings and connect to the wireless network, or verify your wired Ethernet
connection is enabled when using a direct Ethernet connection.
4. On your computer, launch the XControl app and take note of the computer’s IP address (as shown in photo above).
5. On the X32, press the SETUP button and page over to the “network” tab.
6. For IP address use the Computer’s IP address noted in step 4 above EXCEPT change the last number.
7. Next set the subnet mask to 255.255.255.0.
8. The gateway eld can often be left blank. If using a router, ll it in with the router’s’ IP address if you are having
trouble connecting.
9. On your computer, input the X32’s IP address into XControl and click Connect.
To Next Page
Loading...
