BeiJer GN-9289 - IP Address Setup; BOOTP;DHCP and Manual Methods

GN-9289 User Manual
Page 23 of (70)
G-series GN-9289 Modbus TCP_UDP Rev. 1.01.docx
6.4. MODBUS/TCP IP – Address Setup
6.4.1 IP-Address Setup using BOOTP/DHCP Sever
If the adapter BOOTP/DHCP enabled (DIP Pole#9 ON), the adapter sends BOOTP/DHCP request message
of 20 times every 2sec. If BOOTP/DHCP sever does not response, the Adapter applies its IP Address with
EEPROM (Latest saved IP Address).
The following is an example of adapter IP-Address setup that can be used with a third party BOOTP/DHCP
server.
* Beijer BOOTP server