Beisler 100-68 - Aligning the Corner Knife Station as to the Seams

8.3 Aligning the corner knife station as to the seams
Caution: Risk of injury!
Switch the main switch off.
Adjust the corner knife station only with the sewing unit switched off.
Standard checking
The corner incisions must be symmetrical to the seams.
–
Set the maximum sewing length at the control.
–
Iron a piece of interfacing on a workpiece.
Thus the corner incisions are better visible.
–
Make a test seam.
–
Check seam and cutting pattern.
Correction of the corner incision at the seam end
–
Swivel the corner knife station 1 out completely.
3
35
1