Belair 20E - SNMP Command Reference

BelAir20E User Guide BelAir20E Access Methods
April 2, 2012 Confidential Page 28 of 255
Document Number BDTM02201-A01 Standard
SNMP Command
Reference
The following sections show you how to configure SNMP functions.
SNMP Agent
/protocol/snmp/set snmp-agent {enabled | disabled}
/protocol/snmp/show snmp-agent
The set snmp-agent command enables or disables SNMP access.
SNMP Configuration
/protocol/snmp/show config [{v2 | v3 | all}]
Use the show config command to display the current SNMP configuration.
Passwords are only displayed to users with root privileges. See “User Privilege
Levels” on page 35 for details.
Example 1
/protocol/snmp# show config v2
EngineId: 80003d9805000d67091448
Community configuration:
------------------------
Index Name IP Address Privilege
----- ------------------ --------------- -----------
1 public 0.0.0.0 ReadOnly
2 private 10.1.1.70 ReadWrite
Trap configuration:
-------------------
Index IP address Community Version
----- --------------- --------------- -------
1 10.1.1.70 public v1v2
Example 2
/protocol/snmp# show config v3
EngineId: 80003d9805000d67006902
User configuration:
-------------------
User Name IP address Auth Password Privacy Password Privilege
------------------------- --------------- ---- --------------- -------- --------------- ---------
Test 0.0.0.0 MD5 md5md5md5 DES_CBC TEST ReadWrite
Notification configuration:
-------------------
Name Type IP address Timeout Retry Auth Password Privacy Password
--------------- ------ --------------- ------- ----- ---- --------------- ------- ---------
TRAP trap 10.1.1.70 1250 2 MD5 md5md5md5 DES_CBC TRAP