Belair 20E - Card Settings

BelAir20E User Guide Card Settings
April 2, 2012 Confidential Page 67 of 255
Document Number BDTM02201-A01 Standard
Card Settings
This chapter contains the following topics that describe card operations:
• “Determining which Cards are in a Node” on page 67
• “Displaying Card Information” on page 68
• “Card Administrative State” on page 70
• “Restarting a Card” on page 70
Table 6 lists the location of documentation for physical interface parameters.
Determining
which Cards are
in a Node
/mode
/card/mode
Use the mode command to determine <card_type> and <n>.
Table 6: Physical Interface Parameter Settings
Physical Interface
Type
Refer to...
Wi-Fi • “Wi-Fi Radio Configuration Overview” on page 71
• “Configuring Wi-Fi Radio Parameters” on page 72
• “Configuring Wi-Fi Access Point Parameters” on
page 80
• “Wi-Fi AP Security” on page 100
• “Wi-Fi Backhaul Link Configuration” on page 115
• “Mobile Backhaul Mesh” on page 123
• “Mobile Backhaul Point-to-point Links” on
page 127
Ethernet
(1000Base-TX)
• “Ethernet or LAN Interface Settings” on page 64