Belair 20E - Displaying Associated Wireless Clients

BelAir20E User Guide Configuring Wi-Fi Access Point Parameters
April 2, 2012 Confidential Page 83 of 255
Document Number BDTM02201-A01 Standard
Displaying
Associated
Wireless Clients
/interface/wifi-<n>-<m>/show clients [ssid <ssid_index>]
This command displays the list of associated wireless clients for a given SSID. If
no SSID is specified, the displayed list shows all associated clients and their
SSID.
The ssid_index parameter must be a valid SSID index.
In the resulting output:
• The time field displays how long the client has been associated to the BelAir
radio.
• The IP field lists the client's IP address. (s) indicates static IP addressing.
• The identity field lists the 802.1X client identity. It is present for dot1x or
WPA SSIDs.
• The auth field lists the authentication state of the client. See Tabl e 8.
• The dhcp field lists the client DHCP state (applicable only if client uses
dynamic IP addressing). See Table 9 on page 83.
Table 8: Auth Field Value Descriptions
Value Description
unauth default or initial state
auth client is authorized for Open or WEP privacy
eapAuth client is authorized for dot1x, WPA1 or WPA2 privacy
pskErr Possible wrong WPAPSK key configured on client
radto For dot1x, WPA1 or WPA2. Problems connecting to radius
server, possibly because of a network problem.
cltto For dot1x, WPA1 or WPA2. Problems sending EAP packets to
client.
Table 9: DHCP Field Value Descriptions
Value Description
init Client has just connected and has not yet started a DHCP
sequence