BelAir20E User Guide Configuring Wi-Fi Access Point Parameters
April 2, 2012 Confidential Page 80 of 255
Document Number BDTM02201-A01 Standard
Configuring Wi-Fi Access Point Parameters
This chapter describes how to display and configure Wi-Fi Access Point (AP)
parameters, including:
• “Displaying AP Configuration” on page 81
• “AP Custom Rates” on page 81
• “Displaying Associated Wireless Clients” on page 83
• “Displaying Wireless Client Details” on page 85
• “Disconnecting a Wireless Client” on page 85
• “Wireless Client Load Balancing” on page 85
• “Configuring RTS-CTS Handshaking” on page 86
• “Specifying the Beacon Period” on page 86
• “Displaying Client Association Records” on page 87
• “Changing AP Admin State” on page 88
• “AP Service Set Identifiers” on page 88
—“Displaying the SSID Table” on page 89
—“Displaying SSID Details” on page 90
—“Default Management SSID” on page 90
—“Configuring SSIDs” on page 91
—“Upstream User Priority Marking” on page 92
—“Setting Traffic Limits” on page 93
—“Providing Vendor Specific Information” on page 93
—“Changing SSID Admin State” on page 94
• “Out-of-service Advertising” on page 95
• “Filtering Broadcast and Multicast Packets” on page 96
• “Broadcast to Unicast Packet Conversion” on page 96
• “Limiting Upload and Download Rates” on page 97
• “ARP Filtering” on page 97
To Next Page
Loading...