BelAir20E User Guide IP Settings
April 2, 2012 Confidential Page 44 of 255
Document Number BDTM02201-A01 Standard
IP Settings
This chapter contains procedures for managing BelAir20E IP parameters as
follows:
• “Displaying IP Parameters” on page 44
• “Configuring IP Parameters” on page 45
—“Configuring Dynamic IP Addressing” on page 45
—“Renewing the IP Address” on page 46
—“Auto-IP” on page 46
—“Setting a Static IP Address and Subnet Mask” on page 47
—“Static IP Routes” on page 47
• “Configuring the Domain Name System Lookup Service” on page 48
• “Configuring IP Address Notification” on page 48
CAUTION! The BelAir20E uses internal IP addresses in the range of 192.168.1.x,
192.168.2.x and 192.168.3.x. As a result, do not configure the BelAir20E to use
any IP addresses within these ranges.
Displaying IP
Parameters
/protocol/ip/show config
The
/protocol/ip/show config
command displays a detailed view of the system’s
IP configuration.
Example
/protocol/ip# show config
Interfaces:
Address Configured/ Configured/ Accept
Current Current Alloc Fallback Fallback DHCP
Interface Address Netmask Type D Address Netmask Parameters
------------------------------------------------------------------------------------------------
System 10.9.9.20 255.255.255.0 Static 10.9.9.20 255.255.255.0 Disabled
AutoIP: Enabled
Routes:
Destination Netmask Gateway Interface Active
--------------- --------------- --------------- ------------------ ------
No static routes currently configured
DNS:
To Next Page
Loading...