Belair 20E - Configuring Wi-Fi Radio Parameters; Displaying Wi-Fi Radio Configuration

BelAir20E User Guide Configuring Wi-Fi Radio Parameters
April 2, 2012 Confidential Page 72 of 255
Document Number BDTM02201-A01 Standard
Configuring Wi-Fi Radio Parameters
This chapter describes how to display and configure Wi-Fi radio parameters,
including:
• “Displaying Wi-Fi Radio Configuration” on page 73
• “Displaying Configuration Options” on page 74
• “Operating Channel” on page 74
• “Antenna Gain” on page 76
• “Transmit Power Level” on page 76
• “Link Distance” on page 77
• “Dynamic Frequency Selection” on page 77
• “Collision Aware Rate Adaptation” on page 78
• “Rate Aware Fairness” on page 78
• “802.11n Aggregation” on page 78
• “Minimum Receive Threshold” on page 78
• “Changing Wi-Fi Interface Admin State” on page 79
To configure parameters that are specific to Wi-Fi Access Points (APs), see
“Configuring Wi-Fi Access Point Parameters” on page 80.
To configure parameters that are specific to backhaul radios, including the
different types of backhaul links, see “Wi-Fi Backhaul Link Configuration” on
page 115.
See also:
• “Configuring Wi-Fi Access Point Parameters” on page 80
• “Wi-Fi AP Security” on page 100
• “Wi-Fi Backhaul Link Configuration” on page 115
• “Mobile Backhaul Mesh” on page 123